Introduction This experiment investigates magnetic induction, as governed by Faradays number 1 Law. When the magnetic flux threading a circut is changing, an E.M.F. is induced in the circut. The experiment involves dropping a magnet through a bun of wire and observing the result on a PC found background. Equipment Required • A Pico Magnetic knowledgeability Kit • A PC ground oscilloscope with PicoScope software running. We utilise the ADC-212 yet any of our PC based scopes would have been suitable. Experiment Setup |The tube- curve locating is mounted vertically. We used a clamp and |[pic] | |stand. |Figure 1 :- Setup of Equipment | |The coil is connected to channel A of the oscilloscope. | | |PicoScope was clan channel A to the 500mV range (the correct range | | |will depend on the output from your coil).
| | |The timebase was note to 5ms/div | ! | |The actuate was set to repeat so that individually time the magnet was | | |dropped down the tube, the captured wave form was frozen on the | | |display | | |The trigger level was set to +50mV (rising) and the trigger cargo area was| | |set...If you want to get a full essay, pronounce it on our website:
BestEssayCheap.comIf you want to get a full essay, visit our page:
cheap essay
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.